GUI stops responding when adding iSCSI device extents

[Grimeton]

Hi,

just installed the latest amd64 version on an usb thumbdrive. I initialized ZFS and created four ZFS volumes. After this, I went to iSCSI -> Device Extents -> Add device extent.

Then the dialog opens and you can add a name to the extent. When you've done that, and you press the TAB key, the cursor jumps to the "Comment" box and the tooltip is shown. If you don't add a comment and you don't have to change the disk device and just press enter the extent is created, but the tool tip is still opened and the gui stops responding.

Only solution atm is to reload the whole page.

Basically you have todo this:

1. click on 'Add Device Extent"
2. Dialog opens
3. Put in the name
4. Press the tab key
5. Hit enter
6. See the extent created, the dialog gone and the tooltip still there (check the added screenshot).

Browser: Mozilla/5.0 (X11; Linux x86_64; rv:7.0.1) Gecko/20100101 Firefox/7.0.1 Iceweasel/7.0.1)

KR,

Oliver

[Grimeton]

Just had the same situation, but the tree on the left started responding again and the tooltip, which is still opened, became some PITA as it floats on top and you can't close it.

[william]

I believe this is fixed in 8.2 branch.